Elcometer 106/6 Coatings on Concrete Adhesion Tester - Range 0 - 3.5MPa (N/mm²) 0 - 500psi
€1,227.54€998.00
The Elcometer 106/6 adhesion tester has been specifically designed to measure coatings on concrete. Operating in a similar way to the rest of the Elcometer 106 Adhesion Testers, the Elcometer 106/6 allows for a 50mm (2) larger dolly for testing coatings on concrete
Elcometer 106/6 Coatings on Concrete Adhesion Tester
The Elcometer 106/6 adhesion tester has been specifically designed to measure coatings on concrete. Operating in a similar way to the rest of the Elcometer 106 Adhesion Testers, the Elcometer 106/6 allows for a 50mm (2) larger dolly for testing coatings on concrete Fully portable and comes in a carrying case ideal for site tests Hand operated so you don't have to worry about a power supply!
Technical Specification
Part Number
Description
F106----6
Elcometer 106 Coatings on Concrete Adhesion Tester - Scale 6
Range
0 - 3.5MPa (N/mm2) 0 - 500psi
Dimensions
505 x 370 x 120mm (19.9 x 14.6 x 4.7")
Certificate available
Certificate of Calibration: issued for Fixed Calibration equipment and shows readings and traceability.
Packing List
Elcometer 106/6 Coatings on Concrete Adhesion Tester, 5 x 50mm (2”) dollies, support ring, Araldite adhesive, ratchet spanner, carry case and operating instructions
Can be used in accordance with: ASTM D 7234, BS 1881-207, DIN 1048-2, EN 1542, EN 12636
Elcometer 106/6 Coatings on Concrete Adhesion Tester
The Elcometer 106/6 adhesion tester has been specifically designed to measure coatings on concrete. Operating in a similar way to the rest of the Elcometer 106 Adhesion Testers, the Elcometer 106/6 allows for a 50mm (2”) larger dolly for testing coatings on concrete!
Fully portable and comes in a carrying case – ideal for site tests! Hand operated so you don't have to worry about a power supply!
Elcometer 106/6 Coatings on Concrete Adhesion Tester At a glance!
Designed specifically to meet the requirements of measuring coating adhesion on concrete
Designed for a 50mm/2” test dolly.
Easy to use, provides reliable results in both MPa & PSI.
Adhesion V5: 23/05/06 Adhesion
From the largest man-made structures to the smallest household appliances, most manufactured products have a protective or cosmetic coating. Premature failure of this coating can, at the very least, result in costly penalties or rework.
Adhesion testing during the coating process will quantify the strength of the bond between substrate and coating, or between different coating layers or the cohesive strength of some substrates. Routine testing is also used as part of inspection and maintenance procedures to help detect potential coating failures.
Elcometer offer a highly comprehensive range of Adhesion Gauges designed specifically to meet your requirements. These gauges can be split into three categories:
Cross Hatch / Cross Cut Method The coating is cut into small squares, thereby reducing lateral bonding, and the adhesion assessed against ISO, ASTM or Corporate Standards
Pull Off Adhesion Method Tensile Dollies (or stubs) are glued to the coating and, once the adhesive has cured, the force required to pull the dolly off the surface is measured.
Push Off Adhesion Method Similar to the Pull Off Adhesion Test, a dolly is glued to the coating, once the adhesive has cured, however, the dolly is pushed off the surface by the adhesion gauge.
