Fukuda FRD800R Universal Digital Receiver for ALL rotating lasers - Displays distance from grade

Our Fukuda FRD800R laser receiver displays the distance between the detected rotating laser beam and the receiver’s grade reference. This numerical reading helps you assess elevation differences without repeatedly repositioning the receiver to centre the beam.

The digital laser receiver offers a choice of millimetres, centimetres, inches and feet, allowing you to use the units required for your work. A supplied staff bracket and two built-in magnetic mounts provide different ways to position it. Browse our laser level receivers to compare models for your rotating laser setup.

Fukuda FRD800R Distance Readings and Accuracy Settings

The Fukuda FRD800R laser receiver has three selectable accuracy bands: ±1mm for fine detection, ±5mm for coarse detection and ±10mm for large coarse detection. Choose the setting that matches the tolerance of the task, from close-level checks to work where a wider detection band is sufficient.

Its 125mm detecting sensor provides a reception area for locating the rotating beam. As a laser receiver with distance readout, it gives you a numerical elevation difference while the beam is within the supported readout area.

Key specifications include:

• Specified detection range: minimum 600m diameter.
• Display units: millimetres, centimetres, inches and feet.
• Accuracy bands: ±1mm, ±5mm and ±10mm.
• Detection sensor: 125mm.
• Mounting: magnets at the top and left side.
• Levelling aids: two bubble vials.
• Protection: IP54 rating with full rubber protection.
• Power: four AA batteries.
• Automatic shut-off: LCD auto-off after 3 minutes; receiver self-switch-off after 15 minutes.
• Included accessory: staff bracket.
  
  

Checking Elevations with the Fukuda FRD800R

Set up your compatible rotating laser to establish the reference plane. Switch on the Fukuda FRD800R laser receiver, select your units and accuracy band, and face the sensor towards the transmitter. Move the receiver through the beam to obtain a reading.

For staff-based checks, establish a reading at a known benchmark before comparing other points. Keep the staff upright and use a consistent reference when recording measurements. This approach supports level checks during ground preparation, foundation work and general construction.

Match this universal laser receiver to your transmitter before ordering. Our rotary laser levels category provides options for building a suitable levelling setup.

Mounting the Fukuda FRD800R for Site Work

Secure the Fukuda FRD800R laser receiver to a suitable levelling staff using the included bracket. The two bubble vials help you check its orientation during positioning.

Alternatively, use the top or left-side magnet to attach the receiver to a suitable steel surface. Choose a position that leaves the sensor exposed to the beam and the display accessible. Our laser level accessories category includes additional equipment for site setups.

Order Your Fukuda FRD800R Receiver

Order your Fukuda FRD800R laser receiver online, or call us on 01 801 1335 for advice on transmitter compatibility, digital readings and staff mounting.